6/15/2023 0 Comments Udmx atmega8 hex![]() ![]() ![]() Run Tools > Burn Bootloader > w/ Arduino as ISP. (You'll need to select the board and serial port from the Tools menu that correspond to your board.) Wire up the Arduino board and microcontroller as shown in the diagram.Select "Atmega8 optiboot" from the Tools > Board menu. To burn the bootloader, follow these steps: Upload the ArduinoISP sketch onto your Arduino board. You can do this using an Arduino board as an in-system program (ISP). ![]() Remember not to use Atmega8L with this boards.txt settings.īurning the Bootloader If you have a new ATmega8, you'll need to burn the bootloader onto it. Chane avrdude to avrdude1 in new prorammer settings and delete "-Uefuse:w::m You need to find section titled:Ĭopy default lines and paste them after old ones. Platform.txt is in the same directory with boards.txt. You heve to be shure, that lines =avrdude1 and =arduino:avrdude1, contain avrdude1 insted of avrdude. WordPad is much better, but I'm pretty shure that every decent text editor will be as good.Ī=optiboot\optiboot_atmega8.hexĪ=atmega8 _cpu=16000000L Do not use MS notepad it will mess everything up. Open boards.txt, which is in: Arduino\hardware\arduino\avr (in your main Arduino folder).
0 Comments
Leave a Reply. |